No products
Product successfully added to your shopping cart
There are 0 items in your cart. There is 1 item in your cart.
New products
-
2018+ COMPLETE 10 pc FROGZSKIN HOOD KIT
This kit is a direct replacement for all screens on our PRO-MAX hoods...
$139.95 -
2012-2017 COMPLETE 13 pc FROGZSKIN HOOD KIT
This kit is a direct replacement for all screens on our PRO-LITE hoods...
$159.95 -
-
2017.5 BDX PROLITE 950 TURBO 162"
EXTREMELY CLEAN 2017.5 BDX PROLITE 950 TURBO WITH ONLY 200 MILES THIS...
$18,995.00 -
SIDE PANEL EXHAUST FROGZSKIN
great way to keep snow out of your exhaust side belly ban and get the...
$29.95 -
REPLACEMENT POLARIS 800 DURABILITY KIT PISTON
Replacement piston kit for Polaris models with our SSI durability piston...
$179.95 -
-
FIRECAT F6/F7 There are 89 products.
-
50MM THROTTLE BODIES FOR CAT 800 50MM THROTTLE BODIES FOR CAT 800
Pro-Lite 50mm throttle bodies to replace the stock 46mm throttle bodies. 3-4 hp gain over the stock throttle bodies expecially on a ported or big bore motor. Lighter than stock. All of your stock fuel injectors, throttle linkage and tps sensor will swap over. For best results use M1000 intake boots or Boyesen Reeds part number RAD52-2 Pro-Lite 50mm throttle bodies to...
$449.95
In Stock -
RISING RATE FUEL PRESSURE REGULATOR FOR... RISING RATE FUEL PRESSURE REGULATOR FOR...
Rising rate fuel pressure regulator for Cat M series and crossfires. Adjust the set pressure easily and on turbo models it can be used as a rising rate regulator. Replaces the stock regulator in the fuel tank. **CALL FOR BULK PRICING** Rising rate fuel pressure regulator...
$75.00
In Stock -
OIL INJECTION ELIMINATION KIT OIL INJECTION ELIMINATION KIT
Finally an oil injection elimination you do not have to maintain! We use a lubricant injected bushing, this means no greasing, install and forget about it! We have yet to wear one out! Fits 03' - UP 600cc, 700cc, 800cc, 1000cc Arctic Cats (Lay Down Motors) Finally an oil injection elimination...
$34.95
In Stock -
Koso Wideband Air/Fuel Ratio Gauge Koso Wideband Air/Fuel Ratio Gauge
This nice back lit Wideband Air/Fuel Ratio Gauge will give you precise information on your engine. This will help you determine if your engine is running rich or lean. Very good engine tuning tool. ON SALE!! SAVE 30!! This nice back lit Wideband Air/Fuel...
$309.95
In Stock -
KOSO Dual EGT Gauge - Fast Sensors KOSO Dual EGT Gauge - Fast Sensors
This nice dual exhaust temperature gauge will give you precious informations on your engine.The settable warning for each cylinder give the opportunity to set the maximum temperature to reach at up to 2100°F. The color change and the blinking of the screen makes it very easy to see if something is going wrong with the engine. ON SALE NOW!! SAVE $35!! This nice dual exhaust temperature...
$334.95
In Stock -
52MM THROTTLE BODIES FOR CAT 800/700 52MM THROTTLE BODIES FOR CAT 800/700
Pro-Lite 52mm throttle bodies to replace the stock 46mm throttle bodies. 4-5 hp gain over the stock throttle bodies expecially on a ported or big bore motor. Lighter than stock. All of your stock fuel injectors, throttle linkage and tps sensor will swap over. For best results use M1000 intake boots or Boyesen Reeds part number RAD56-2 Pro-Lite 52mm throttle bodies to...
$469.95
In Stock -
BDX 10.4" DIAMETER CLUTCH REPLACEMENT... BDX 10.4" DIAMETER CLUTCH REPLACEMENT...
BDX 10.4 DIAMETER REPLACEMENT SHEAVES FOR DIAMOND DRIVE MODELS ** 2005-2006 models with the threaded adjuster need to upgrade to part number 50001-BK adjuster which isn't threaded. BDX 10.4 DIAMETER REPLACEMENT SHEAVES...
$289.95
In Stock -
Arctic Cat 700 BDX Power Valve Plus... Arctic Cat 700 BDX Power Valve Plus...
Finally a kit that you will lose 4 lbs of unwanted weight, no more misadjusted cables, broken cables, or cable routing problems when you put after market pipes on your sled and still gives you the same or better performance the factory power valves. Finally a kit that you will lose 4...
$199.95
In Stock -
DIAMOND DRIVE CLUTCH BOLT AND BELT... DIAMOND DRIVE CLUTCH BOLT AND BELT...
If you are purchasing one of our 10.4 diameter clutches and you have a screw in belt adjuster, then you need to use this hardware and vented bolt kit to hold the clutch on. It will work as a replacement for all years of diamond drives. This also is what is used to adjust the belt defection. If you are purchasing one of our 10.4...
$49.95
In Stock -
DIAMOND DRIVE SEAL KITS FOR 2005 MODELS DIAMOND DRIVE SEAL KITS FOR 2005 MODELS
SEAL KIT FOR 2005 MODEL DIAMOND DRIVES SEAL KIT FOR 2005 MODEL DIAMOND DRIVES
$21.95
In Stock -
DIAMOND DRIVE SEAL KIT 2006 MODELS DIAMOND DRIVE SEAL KIT 2006 MODELS
DIAMOND DRIVE SEAL KIT 2006 MODELS DIAMOND DRIVE SEAL KIT 2006 MODELS
$21.95
In Stock -
XTREME DUTY OIL CHANGE KIT 3 0Z XTREME DUTY OIL CHANGE KIT 3 0Z
XTREME DUTY OIL CHANGE KIT 3 OZ. FOR NON REVERSE MODELS XTREME DUTY OIL CHANGE KIT 3 OZ. FOR...
$5.95
In Stock -
04-06, 09-11 5 PINION PLANETARY/FWD ONLY... 04-06, 09-11 5 PINION PLANETARY/FWD ONLY...
04-06, 09-11 5 PINION PLANETARY/FWD ONLY MODEL 04-06, 09-11 5 PINION PLANETARY/FWD...
$179.95
In Stock -
2004-2006 RING GEAR 2004-2006 RING GEAR
2004-06 DIAMOND DRIVE RING GEAR 2004-06 DIAMOND DRIVE RING GEAR
$249.95
In Stock -
SUPER LIGHT CERAMIC BRAKE ROTOR FOR... SUPER LIGHT CERAMIC BRAKE ROTOR FOR...
Ceramic lightweight brake rotor for 2004-2011 diamond drives. They are 2 lbs lighter than stock! And the brake sensitivity is improved a lot too. Make sure to order our brake pads which are required. Part number 51001 SALE SALE SALE!!! NORMALLY $249.95!! SAVE $170!! Ceramic lightweight brake rotor for...
$79.95
In Stock -
BRAKE PADS FOR CERAMIC BRAKE ROTOR-DIAMOND... BRAKE PADS FOR CERAMIC BRAKE ROTOR-DIAMOND...
Brake pads to be used specifically for our super lightweight ceramic brake rotor. Brake pads to be used specifically...
$29.95
In Stock -
BDX SPRING TOOL, DIAMOND DRIVE AND TORSION... BDX SPRING TOOL, DIAMOND DRIVE AND TORSION...
Adjust your adjustable spring rate clutch with ease using the BDX Spring Tool! For Diamond Drives with adjustable spring tension end cap. The back side accepts a spark plug wrench socket to make it easy to turn. When installing our clutch kits which have the torsion spring style helix, use this tool to fit into the endcap to adjust the spring tension. Adjust your adjustable spring rate...
$24.95
In Stock -
Auto Tune for Power Commander Auto Tune for Power Commander
This version is a "universal fit", single O2 sensor kit. It can be used on any vehicle that has a PCV installed on it. It comes with a single O2 sensor, "cut to length" sensor cable, control module, O2 sensor, one weld boss kit, a CAN connection cable, and CAN termination plug. It requires a ground and +12 volt connection to be made using the supplied... This version is a "universal fit",...
$324.95
In Stock -
Dyno Jet POD-300 Display Dyno Jet POD-300 Display
The POD-300 is an accessory display for Dynojet devices that support DJ-CAN; including the popular Power Commander V, AutoTune, WideBand 2, and CMD. The POD-300 is an accessory display...
$249.95
In Stock -
POD-300 Handlebar Mount Kit, BLACK POD-300 Handlebar Mount Kit, BLACK
POD-300 Handlebar Mount Kit, BLACK POD-300 Handlebar Mount Kit, BLACK
$99.95
In Stock -
PCV MAP SWITCH PCV MAP SWITCH
Use this map switch to toggle between dual maps on your power commander Use this map switch to toggle between...
$49.95
In Stock -
Xtreme Lite Weight Gear Set 68/52 (1.71... Xtreme Lite Weight Gear Set 68/52 (1.71...
One-piece forged, precision ground, liteweight gears! A wide variety of ratios available, non-reverse (04, 05’, 06’ and 09’) and reverse (07’ – 08’). The transfer gears are one-piece forged (not welded as OE 04’ – 08’) with 5 window opening to provide superior splash lubrication to the rear bearings of the gears which gives you longer bearing life! One-piece forged, precision ground,...
$249.95
In Stock -
BDX Xtreme Lite Weight Gear Set 62/58... BDX Xtreme Lite Weight Gear Set 62/58...
Our one-piece forged, precision ground, liteweight gears! A wide variety of ratios available, non-reverse (04, 05’, 06’ and 09’) and reverse (07’ – 08’). The transfer gears are one-piece forged (not welded as OE 04’ – 08’) with 5 window opening to provide superior splash lubrication to the rear bearings of the gears which gives you longer bearing life! Our one-piece forged, precision...
$249.95
In Stock -
Xtreme Lite Weight Gear Set 60/60 (2.24... Xtreme Lite Weight Gear Set 60/60 (2.24...
Our one-piece forged, precision ground, liteweight gears! A wide variety of ratios available, non-reverse (04, 05’, 06’ and 09’) and reverse (07’ – 08’). The transfer gears are one-piece forged (not welded as OE 04’ – 08’) with 5 window opening to provide superior splash lubrication to the rear bearings of the gears which gives you longer bearing life! Our one-piece forged, precision...
$249.95
In Stock -
Xtreme Lite Weight Gear Set 57/63 (2.48... Xtreme Lite Weight Gear Set 57/63 (2.48...
Our one-piece forged, precision ground, liteweight gears! A wide variety of ratios available, non-reverse (04, 05’, 06’ and 09’) and reverse (07’ – 08’). The transfer gears are one-piece forged (not welded as OE 04’ – 08’) with 5 window opening to provide superior splash lubrication to the rear bearings of the gears which gives you longer bearing life! Our one-piece forged, precision...
$249.95
In Stock
